Contrex M-Traverse Manual de usuario descargar pdf (Pagina 154)

5 - 7

to move the Follower mechanism to “Home”. Jog can also

be used when you need brief bursts of speed to align the

Follower mechanism. When you activate Jog, the RPMs

increase at the acceleration rate that you specified in

Acceleration/Deceleration (CP-60) until the Jog Setpoint

(CP-61) is achieved. When Jog is terminated, the RPMs

return to zero immediately. The Jog direction is deter-

mined by the Jog Forward/Reverse Input (J4, pins 15,16),

which controls the direction of the Speed Command

Output. The Drive Enable discrete output is active during

the Jog mode.

Jog Setpoint See Appendix C; CP-61.

Keypad Error See Appendix C; MV-50.

Lead Frequency See Appendix C; MV-41.

Lead Job Size See Appendix C; MV-80.

Lead Position See Appendix C; MV-43.

Lead PPR Reel See Appendix C; CP-16.

LED Display The two digit Parameter Code is displayed in the lower

LED Display. The Parameter Code's value is displayed in

the upper LED display. This value can be up to six digits.

Line Notch Counter See Appendix C; MV-59.

Max RPM Follower See Appendix C; CP-19.

Mode of Operation The method used to operate your system, for example

Direct mode or Follower mode.

Monitor Variables Monitor Variables (MVs) monitor the performance of the

M–Traverse and the system which the M–Traverse is

controlling. Monitor Variables also confirm the wiring, the

tuning and assist with troubleshooting. MVs can be

accessed at any time during the M–Traverse's operation,

including during Run, Jog and F–Stop. There are four

categories of Monitor Variables: Input Monitoring, Output

Monitoring, Performance Monitoring and Status Monitor-

ing.

Numeric Keys Use the numeric keys to enter a Parameter Code for either

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 201 202

Sin comentarios

Contrex M-Traverse Manual de usuario Pagina 154