Contrex M-Traverse Manual de usuario descargar pdf (Pagina 114)

3 - 67

Parameter Send

Use the Parameter Send to change any of the M–Traverse's Control Parameters.

Table 3-38 Parameter Send - Host Transmission

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Dev# Dev# MSG Par# Par# Data Data Data Data Data Data Data Data Data

STX 10s 1s Type 10s 1s 10mil 1mil 100th 10th 1th 100s 10s 1s

Forma

t ETX

STX 0-9 0-9 3 0-9 0-9 0 0 0-9 0-9 0-9 0-9 0-9 0-9 0-; ETX

Character

DESC

ASCII

The following is a description of the Parameter Send-Host Transmission Characters.

Character 1 - STX:

This is the first character in the character string. None of the other characters will

be recognized without this character prefix. Always use the ASCII “STX” character

to enable the M–Traverse's receive buffer.

Characters 2, 3 - Device Number:

These characters are the access address of the M–Traverse. This number

identifies individual M–Traverses on a multidrop system. The M–Traverse will

accept data only if this number matches the M–Traverse's address (CP-70), with

the exception of a “00” address. The “00” address is universally accepted by all

M–Traverses that are on the RS422 Serial Communications Interface.

Character 4 - Message Type:

This character should always be “3”.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 201 202

Sin comentarios

Contrex M-Traverse Manual de usuario Pagina 114