Contrex MLP-Trim Manual de usuario descargar pdf (Pagina 182)

C - 14

CP-70 DEVICE ADDRESS

Device Address (CP-70) is the physical address of the MLP–Trim, which can be set from 1 to 32.

Each individual MLP–Trim on a multidrop RS485 communications link needs a unique Device

Address. The address “00” will be globally accepted by all of the MLP–Trims on a

communications link, however, they will not send a response message back to the host computer

when this global address is used.

CP-71 BAUD RATE

There are six different baud rates (data rates) for the MLP–Trim. Enter the number for the

required function in Baud Rate (CP-71), as listed below.

1 = 300 Baud

2 = 600 Baud

3 = 1200 Baud

4 = 2400 Baud

5 = 4800 Baud

6 = 9600 Baud

CP-72 CHARACTER FORMAT

The MLP–Trim uses three different character formats. Enter the number for the required format

in Character Format (CP-72), as listed below.

1 = 8 Data Bits, No Parity, One Stop Bit

2 = 7 Data Bits, Even Parity, One Stop Bit

3 = 8 Data Bits, No Parity, Two Stop Bit

CP-73 CONTROL MASK

The Serial Communications can control some of the logic input functions. Enter the number for

the required functions in Control Mask (CP-73), as listed below.

0 = F–Stop only

1 = F–Stop, Run, R–Stop

2 = F–Stop, Master/Follower, Setpoint Select

3 = All of the above

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 215 216

Sin comentarios

Contrex MLP-Trim Manual de usuario Pagina 182