Contrex ML-Drive Manual de usuario descargar pdf (Pagina 125)

Glossary - 5

Drive Enable The Drive Enable output is activated based on the

Ramped Reference (MP-46) and the feedback. The

Ramped Reference is the calculated setpoint that is output

from the Acceleration/Deceleration routine.

See Appendix C; CP-74.

Engineering Units (E.U.) Master Engineering Units are the units of measure that

your system operates at, such as, RPMs, gallons per hour,

feet per minute. Follower Engineering Units is the number

that will represent the setpoint when the Lead and Follower

are operating at maximum capacity. Refer to Appendix C;

CP- 20 and CP-21.

EEPROM The EEPROM is where the default Control Parameters are

stored. This is not to be confused with the PROM chip

(which is the software for the ML-Drive).

F–Stop One of four operating states. F–Stop brings the

ML-Drive's drive output to an immediate Zero. F–Stop has

priority over the other operating states.

Follower Mode A complex multi-drive system. The scaling format allows

the operator to enter the setpoint as either a ratio or

percentage. The ML-Drive compares the setpoint ratio or

percentage to the Follower sensor shaft feedback and

Lead sensor shaft to calculate any speed error. When the

ML-Drive finds speed error, the control algorithm adjusts

the drive output and reduces the error to zero.

Gain See Appendix C;CP-65.

Hardwired Inputs that are wire shorted rather than using push buttons

or switches.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 177 178

Sin comentarios

Contrex ML-Drive Manual de usuario Pagina 125